Applies labels to the side or top of stationary boxes in adaptive manner with respect to the distance of the box.
Applies a label on the side or two labels – one on the front and one on the side – on stationary objects (with the box stopping in two positions) or slow moving objects (with stops).
Applies a label on the side or top of moving boxes if the size of the boxes is very variable using an air jet with moved pad and photocell to locate the correct spitting distance of the label automatically.
This model is provided with a high-frequency fixed air jet (not moved by a piston) capable of accurately “spitting” the label to a distance of 80 mm from its surface and thus until approximately 50 mm of distance from the clearance of the labelling machine. Suited for high-frequency application on moving objects (also at high speed). Use of the application finishing device is recommended in case of surfaces with poor adhesion. The device consists of a soft rubber roller which presses the label to apply it (after labelling).
This model has a guided piston and a label gripping pad with vacuum generator and sensor to monitor actual picking. A special mechanism controlled by a micro-cylinder allows the pad to pick the newly printed and trimmed label from the silicon-coated paper very accurately. The label is then applied on the object with equally high accuracy. Ideal for label size min. H 20 mm x B 8 mm / max. H 80 mm x B 20 mm.
Applies three labels – one on the advancing front face, one on the side and one on the back – in stationary position with the pallet stopping in three positions.
The linear type applicator is equipped with a series of servo-controlled pneumatic devices and controlled by sensors
This model applies labels to bulging surfaces of a stationary object using a wrap-around pad.
Applies a long label in the corner on stationary boxes using a linear piston applicator with finishing roller fitted on-board.
Linear movement applicator. It is suited to applying small labels inside pipes or spools. The applicator consists of a driven piston with a max. stroke of 350 mm and a label-pick up pad by way of vacuum generation and a sensor that detects the actual pick-up. A special mechanism, controlled by a micro-cylinder, allows the micro-label to be picked up after it has been printed and to be applied precisely onto the object to be labelled.
Applies a label on the side or top of moving boxes is the speed of the linear is less than 25 m/min and the boxes all pass at the same distance from the printer.
Applies frontal labels on high-frequency moving boxes and bundles with short, variable gaps between boxes.
After printing, the smart label is taken to the applicator pad and printed in radio-frequency. The label is read and rejected if it is not
correct. It is then automatically applied onto the object (pallet) and checked once again.